Standard Shipping is Free !
For priority shipping please contact us.
The Taranis Stereo Power Amplifier brings a new performance price point for Audiophiles. Based on the Hypex Ncore NC500, it allows audiophiles to enjoy some of the benefits of the NCORE and Veritas technology, at a lower price.
The Taranis is designed with ultra-low distortion from input to output, and employs a specially designed high end input stage with a high current drive; together, these provide the output stage with ease, speed, detail, and power like no other.
Using the Hypex Ncore NC500, which is an Ncore output stage, and a custom input stage the Taranis Stereo Amplifier is a high end amplifier packaged in an affordable, eye catching chassis with power meters.
The input stage, usually found in the most expensive equipment, is a fully differential design for maximum noise rejection with high input impedance of 100k. The input stage provides a full peak to peak signal of 13.5volts with 300mA of current to the output stage for fast, clean high performance, all with ultra low distortion. It is run hot to give you that extra edge of musical sound. There is a full separate power supply filter just for the input stage which is comprised of 2 separate stages, an input buffer for full high impedance isolation and a differential high current line driver.
To deliver the fast transient speed of high end amplifiers, and the voltage that can drive Electrostaic speakers with ease, the Taranis Stereo Amplifier uses the same power supply as the VERITAS Monoblock Power Amplifiers, providing low noise, high dynamics and high voltage that very few linear power supplies can match.
The chassis used for the Taranis Power Supply capitalizes on the chassis used for the Jens Phono stage, which is a steel chassis for reduced EMI/RFI interference. For eye catching looks and build quality, Mirror finish stainless steel front panel is used.
Power meters display the power from -60db to 0db in 3db steps. -60db to -21db is in green LEDS’s,
-18db to -12db is in yellow and -9db to 0db is in Red LED’s.
To ensure the best signal transfer, silver plated, pure copper wire with Teflon sleeving is used throughout. Cardas XLR inputs have gold plated housing with rhodium plated case and silver plated copper pins for the best connections. The Speaker binding posts are pure copper plated with Rhodium for good signal transfer as well as longevity. Furutech gold plated IEC is also used.
From End to End the Taranis Stereo Amplifier is a statement in quality. The quality of sound, the quality of build and the quality of presentation.
FREE SHIPPING WORLDWIDE (Please Contact us for any Restrictions)
● Silver plated pure copper speaker posts for banana or spades
XLR Balanced input with silver plated pins
Steel chassis for EMI/RFI protection in and out
Power meters with 3db steps.
Stillpoints Ultramini Risers
Waveform Fidelity Power Cord
Synergistic Red Fuse
400 watts/8 ohms
600 watts/4 ohms
1.5milli ohms output impedance
100k input impedance
0-50khz +0/-3db Frequency response
+/- 80 volt Maximum output
26 Amp Maximu Output
130db Signal to noise
Specifications subject to change without notice.